Setting method: Button press continued 3s digital tube starts flashing, the system enters the adjustment mode, release the button every time you press the button, the digital tube digital for a number from the table in the selected mode until digital digital display on the user corresponding the figures far, and other digital display stop flashing or again press key 3s or more to complete the set. (Annex modulation timetable) Mode of presentation Pure light control (0): when there is no sun, the light intensity down to the start point, the controller delay recognized in 10 minutes after the start signal to set the parameters of the opening of the load, the load began to work; intensity rose to start when the sun point, controller delay confirmation closed off signal output, load stop working 10 minutes. Light control + time control (1 to 4): start the same process with the pure light control, when the load of work to set the time automatically closed, set for 1 to 14 hours. Manual mode (5): In this mode the user can be provided by key control opening and closing of the load, regardless of whether the day or night. This mode is used for some special load occasions or debugging. Debug mode (6): used for system debugging, and the light signals that turn off the load the matte signal the opening of the load, and to facilitate the installation of the correctness of the inspection system installation debugging. Normally open mode (7): Power-load has been to keep the output state, this mode is suitable for 24-hour power supply load. Although the manufacturers show slightly different, but the method is the same, as long as you control your manual settings like